A fire pit can be made near the shelter and I recommend you use heat reflectors (boulders or a stack of logs, one on top of the other) to reflect heat back to your shelter. Make this fire pit no closer than 10 feet to your shelter. It is also important to line the floor of your shelter with pine boughs to protect you from the chill of sleeping on a cold ground. Place your gear and enough fire starting materials in the shelter immediately after construction. This provides you with enough wood to get a morning fire going as well as prevents gear being lost. Falling snow will quickly cover any object left unattended in a very short time.
One shelter I use most of the time is a simple lean-to. This type of shelter is great when you need a shelter quickly, or if there is not enough snow for making a true arctic shelter. I simply tie a cord between two trees, just as I explained in A frame shelter above. I then drape about a foot of a tarp or poncho over the line, tie a cord to the grommets on the ends of the material and run the cord down to two stakes I have stuck securely into the ground. My next step is to use stakes at the other end of the material to secure in to the ground. Once again, I cover the roof with pine boughs. If snow is available, I add snow to the pine boughs also. Remember, snow is a great insulator!
And, like in all cold weather shelters, be sure to line the shelter with pine boughs to insulate you from the cold ground. Once the floor is lined, you should make a fire pit in front of the shelter. I never build a fire any closer than 10 feet (pine boughs burn very quickly). If you place a heat reflector on the side opposite of the shelter entrance you will be surprised how warm the shelter will be. The advantage to this type of shelter is the speed and ease of which it can be constructed. In a real emergency, speed may make the difference between life and death.
If you have the time to make one, a snow trench shelter is one of the best. I have spent days in one of them and I know from experience they work very well.
Your first step is to dig down into the snow and clear a trench about three feet wide, three feet deep and seven feet long. This is just a little longer and wider than most people are, to allow you to store your field gear in the shelter. But, make sure you make it roomy enough. Keep in mind that you are looking for emergency protection from the environment, not a suite. The actual size used in construction is an individual preference, depending on your body size and amount of gear you have, but I want a small and compact shelter with only my immediate needs in mind.
As soon as you have the trench made, line the floor of the shelter with pine boughs from the nearby pine trees. Other sources of insulation can be used if pine is not available where you are (If you survive an aircraft crash, the insulation from the walls or the material from the seats on an aircraft provide excellent protection from a cold sleeping surface). I suggest you place the boughs a little over a foot thick. I would prefer to pile them higher, but you have to be able to crawl into the thing once you have a roof on it. I have discovered, in my opinion, that you can never have too much floor insulation in a survival shelter.
Next, put your gear in the shelter up against the far wall, away from the entrance. Now you can start gathering up logs and limbs to cover the snow trench. Make sure you avoid rotted wood (the weight of the insulating material and snow may make it collapse) for the roof. Starting at the end opposite the entrance, I lay the logs and limbs over the open trench until it is all covered with the exception of a small opening. This opening would be the shelters entrance. You will have to estimate the size of your entrance based on your body size, but keep it as small as possible.
Also, made sure the logs overlapped the sides of the snow trench by about a foot on each side. This will give the roof strength and additional support. After the logs are in place, cover the top of the shelter with pine boughs. These pine boughs will provide insulation for your shelter. This insulation will prevent body heat from escaping and help keep the shelter protected from the wind and elements.
Once the boughs were placed on top, covered them with any material you may have. If you don’t have anything, you can still make the shelter. Just make sure you secure each corner of the material to keep it from moving as you pile snow of it. I recommend you anchored the edges the material with wooden stakes. Once the material has been secured, begin covering it with snow.
As you work on any shelter, avoid over heating. If you get too hot remove a layer of clothing. It is important to avoid sweating because of the danger of the sweat freezing. Also, if you feel yourself becoming too warm, stop for a few minutes and cool down. It is not a bad idea to stop at times and maybe have a hot drink. Just make sure you drink lots of water in cold weather conditions to avoid dehydration. I know it sound insane, but dehydration is a serious cold weather problem. I usually drink hot water frequently, because it assists in keeping my body warm and prevents dehydration.
Once the shelter has been constructed crawl inside and poked a hole approximately three inches in diameter in the top. This hole is to allow for ventilation. If you plan to burn a candle in the shelter (plus you will need some fresh air) you will have to constantly checking to make sure the hole stays open. Without the ventilation, and with the candle burning, carbon monoxide poisoning was a real threat. Always keep your shelter well ventilated.
Your last step is to make a door for your shelter. You can use a poncho, tarp, space blanket, etc., and spread it out on the snow near the entrance to your shelter. Then, pile snow on the material until your have enough snow to block the hole used for your entrance. Pull the ends and sides of the material together and tied them in place using some cord or material. You now had a door, roughly the shape of a ball. You can use the ends of the material as a crude door handle to pull the “door” closed once you are inside Survival shelters are easy to make. You can make the lean-to, “A” frame, and tree pit even when there is no snow around. Just complete all of the steps except the part about adding snow. In the desert you can add a dead air space (a good insulator in hot weather) to your shelter by placing another material over the first material you used during the construction of your shelter. Keep the material separated by placed brush between the materials.
The best shelters for general use are the lean-to or the “A” fame designs. They are easy to make and construction takes just a little time. Always consider what you need insulation from, the heat or the cold. In most cases we just need a shelter for comfort (rain or wind) or for psychological reasons. I do, nonetheless, always suggest a shelter for any survival situation. A good shelter will keep you rested, healthy, and if nothing else, happy. Take care, stay safe, and I will see you on America’s trails!
author website: visit | author bio
Pages: 1 2
Worlds Largest Grizzly Bear
Hunting, Shooting, And Fishing Games
Free Printable Targets
Whitetail Wallpaper
Wild Animal Sound Bytes
Add our